![]() They will negotiate to correct duplex and highest possible rate. Use these modules only with auto-negotiation enabled, forced link speeds are not supported. Table that states in what link rates if mounted in specific MikroTik devices S-RJ01 module will be able to work. CRS504-4XQ-OUT - reduce IP code from IP66 to IP54.CCR2004-1G-2XS-PCIe - supports only the same speed in both SFP28 ports (2 x 25G or 2 x 10G modes). ![]() ![]() CCR2004-1G-12S+2XS - supports up to 6 simultaneous S+RJ10 modules.XS+31LC10D, XS+2733LC15D - full support has been added to CSS/CRS326-24G-2S+ and CRS328-24P-4S+ switches manufactured from October 2021.RBFTC11 - works connected to other device 1G SFP port.CSS/CRS305-1G-4S+ - supports up to 2 simultaneous S+RJ10 modules.CSS/CRS326-24S+2Q+ - supports up to 12 simultaneous S+RJ10 modules.Q+BC0003-S+, Q+BC0003-S+ - SFP+ connector support in the SFP+/SFP28 cages.Up 4x S+RJ10 are supported when PoE-in Voltage = 24V. CSS/CRS309-1G-8S+ - 8x S+RJ10 are supported if PoE-in Voltage >30V.CSS/CRS317-1G-16S+ - power controller supports up to 10 simultaneous S+RJ10 modules.CRS226-24G-2S+, CRS210-8G-2S+ - Only SFP+1 interface supports SFP 1.25G fiber optic transceivers, SFP+2 works only with 10G transceivers/links.CCR1016-12S-1S+, CRS212-1G-10S-1S+ - SFP+1 interface does not work on any other link speed than 10G (does not support 1.25G fiber optic transceivers).Note: MikroTik devices and SFP/SFP+/SFP28/QSFP+/QSFP28 modules do not have any restrictions for other vendor equipment.Īs long as the other vendor modules and devices comply with transceiver multi-source agreement (MSA) they should be compatible with MikroTik.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |